How do you adjust the shaft length on a trolling motor?

Can you change shaft length on trolling motor?

If the shaft ends up being a bit too long, you can always adjust the shaft depth upward with the depth collar adjustment found on nearly all trolling motors. But if you pick a shaft that’s too short, you’re simply out of luck.

Can you adjust shaft length Minn Kota?

While it would be cost-prohibitive to lengthen the shaft of any trolling motor, yes, in some cases the shaft of a trolling motor can be shortened. Only models from the below motors families are capable of having their motor shafts shortened: Endura. Endura Max.

How is Minn Kota shaft length measured?

Measure down from the mounting surface of the transom or bow to the water level. Add 5″ to waterline measurement for fishing in rough water. Add 12″ to waterline measurement for steering a hand control motor while standing. Use this measurement and the tables below to find the appropriate shaft length.

How far should a trolling motor be in the water?

A trolling motor’s ideal propeller should be at a depth that keeps about 6 inches of water above the blades. In other words, the centerline of the motor and the prop shaft should be about 12-18 inches below the waterline, depending on the make, model and dimensions of the trolling motor.

IT IS INTERESTING:  Is rust bad for my car?

How long should a kayak trolling motor shaft be?

In order to get the correct shaft length needed for your boat, you first have to measure the distance from the mounting spot on the transom, down to the waterline. Then, take this measurement and add 20” to get the desired shaft length. If you are stuck between two sizes, err on the larger size.

What are trolling motor shafts made of?

The tube contains a flexible shaft formed of three coils of phosphor bronze. This tube extends down and out into the water, where it carries a propeller, and at the inboard end an electric Motor is attached, which is itself driven by batteries.” It was invented and sold by the Electric Boat company.

What is the diameter of a trolling motor shaft?

The Bullnose Rudder clamp fits a perfect 1 1/8″ diameter shaft which is a very standard measurement for many trolling motor companies. If the shaft measures a little slimmer, no problem, there is foam tape in the packaging for thinner shafts.